Dreno Felt PE
Needled and hot-calendered nonwoven polyester geotextile.
Dreno Felt PE-FIX
100% non-woven geotextile made of polyester fibre, mechanically needled and calendared, without chemical treatment.
Dreno Felt PP
100% isotactic polypropylene nonwoven needled and hot-calendered geotextile.
Dreno Felt PPT
High performance 100% isotactic polypropylene nonwoven needled and hot-calendered geotextile, thermally stabilised on both sides.
Fixing Plate
Sheet metal fixing plate made of galvanised steel bonded to TPO or PVC membrane, resistant to atmospheric agents and UV rays.
Flashing Adhesive
Elastomer base contact adhesive for bonding membranes (versions without nonwoven fabric backing) to clay masonry, wood, metal and other suitable substrates.
Fuse Prep Plus
Detergent used for the SINTOFOIL membrane when it is dirty or oxidised on the surface as a result of exposure to atmospheric agents.
L-Shaped Perimeter profile
Perimeter profile in L-shaped plasticised panel with 16.6 cm development. Perimeter covering cap at the end of containment element.
Laminated Metal Sheets
Panel consisting of sheet steel 0.6mm, with top side pre-bonded to a 0.6 mm SINTOFOIL ST or PVC sheet. The lower side of the sheet is protected with a special anti-corrosion treatment.
Microfoil
Low density polyethylene LDPE, micro-perforated film.
Predrilled Metal Bar
Non-coated pre-bored bar in galvanised sheet metal for SINTOFOIL (TPO / FPA) and SINTOPLAN (PVC).
Prefabricated Accessories
Prefabricated accessories obtained by injection of PVC-P granules and prefabricated accessories obtained by injection of TPO/FPA “Flexible Polypropylene Alloy” granules.
Profile for Sealing
Wall profile in plasticised sheet with development 7 cm, suitable for sealing with TPO and PVC. Mechanical fixed.
PVC-P Pasta
Sealing compound based on synthetic resins in organic solvents. Mainly used to seal joints in SINTOPLAN PVC-P membranes after hot air welding.
Rubberfix® System
The RUBBERFIX ® SYSTEM is ideal for anchoring traditional photovoltaic modules (or similar appliances) on roofs with exposed waterproof covering.
Sistema Emifix®
Accurate support system that uses the welding technology by induction heating. The fastener units consist of screw
or plug, chosen by the manufacturer, fixing based on the support, with relative washer coated with treatment in PVC-P
or TPO and protective element, in the presence of EPS insulating panels.
